Exit efficiency: how much of the move did you keep?
Exit efficiency is the share of the best available move that a trade actually kept. Nobody keeps all of it, and one trade says nothing. The pattern over many does.
The measurement
While a trade is open, price reaches a best point: the highest price for a long, the lowest for a short. The distance from your entry to that best point is the move that was available. The distance from your entry to your exit is the move you kept.
Exit efficiency is the second divided by the first.
A long entered at 100. The highest price while it was open was 110. It was closed at 106. Available: 10. Kept: 6. Efficiency: 6 / 10 = 60%.
A short entered at 200. The lowest price while open was 180. It was closed at 188. Available: 20. Kept: 12. Efficiency: 12 / 20 = 60%.
Losing trades have a number too
A long entered at 100 rose to 103 and was then closed at 98. Available: 3. Kept: -2. Efficiency: -2 / 3, about -67%.
A negative figure means the trade was in profit at some point and ended as a loss. One such trade is normal. Stops exist so that failed ideas end. A record full of them is worth a closer look, which is the subject of the rest of this post.
If a trade never went into profit at all, there was no available move and the number is not defined. Leave those out of the average and count them separately.
Why nobody keeps 100%
Keeping 100% means closing at the exact best price. That price is only known afterwards. While the trade is open, the high so far and the final high look the same.
Every exit method gives something back on purpose. A trailing stop has to sit some distance behind price, or normal wobble will trigger it. A fixed target leaves the trade early whenever price runs past it. Waiting for a reversal signal means the reversal has already begun by the time you act.
So a perfect score is not the goal, and a low score on one trade is not a mistake. Treat any trading record that shows efficiency near 100% as suspect.
Read it as a pattern
The useful reading starts at about 30 trades or more, grouped by setup.
Consistently low efficiency on winning trades can mean targets are too close for the moves this setup produces, or that profits are being taken out of nervousness. Many negative figures can mean stops are left at the original level long after the trade has moved, or that targets are too far and price turns before reaching them.
Compare setups with each other. If one averages 55% and another 20%, they may need different exits. One rule for every trade may fit neither.
The trade-off hiding inside it
Efficiency cannot be pushed up for free. A tighter trailing stop keeps more of small moves and cuts the big ones short. A looser one keeps more of the big moves and gives back more on the many small ones.
So judge a change of exit by total result over the whole set of trades, in R (multiples of the amount risked), and not by the efficiency figure alone. It is possible to raise average efficiency and lower total profit at the same time, by turning a few large winners into many medium ones.
What it does not prove
Efficiency is measured with hindsight. It tells you what a perfect exit would have captured, and that exit was never on offer. A low number does not show that a better exit rule existed.
It also ignores what happened after you closed. A trade closed at 106 with a high of 110 scores 60%, whether price later fell to 90 or rose to 150.
Your trading record on Candlesview shows this figure for paper trades, worked out from the best price recorded while each trade was open, so the pattern can be read across many trades.
To take away
- Exit efficiency is the move kept divided by the best move available while the trade was open.
- No exit method keeps 100%, because the best price is only known afterwards.
- Read it across 30 or more trades per setup, alongside total result in R.
Try it
Keep reading
A short pre-trade checklist per setup, ticked honestly, turns a trading record into something you can question. It shows patterns. It does not prove causes.
13 November 2026Testing ideas · 4 minCompare every backtest with simply holdingA backtest that made 18% sounds good until you learn the market rose 30% over the same months. The comparison with holding is the first check, not the last.
21 November 2026Testing ideas · 5 minEight matches is not evidenceA scan matched 8 times and price rose after 6 of them. That feels like 75%. Here is why it says almost nothing, and what to compare it with before believing it.
20 November 2026Education only. Nothing here is financial advice or a recommendation to buy or sell anything; examples are arithmetic, not results. Trading involves a high risk of losing money.